Monday, November 3, 2014

Connect Systems CS7000: Schmatics

"I just loaded the current CS7000 Schematic from the manufacturer. I just got this last night and I do not know the following:

1. Does the changes from the original CS700 match what I asked them to do
2. Did I make any mistakes in my instructions to them

If anyone sees any obvious mistakes please post them and I will analyze what you posted. The changes from the CS700 to the CS7000 was as follows:
1. Add AMBE 3000R Chip
2. Remove any unnecessary parts based on the analog protocol being done in firmware
3. Add better filters for the A/D and D/A converter
4. Make any changes necessary to achieve above goals 
Jerry Wanger KK6LFS"

No comments:

Post a Comment